Quantum DAT 160 Uživatelská příručka stáhnout pdf (Strana 23)

Chapter 2 Installing Internal Tape Drives

Installing Your Drive

Quantum DAT 160 User’s Guide 9

Installing Your Drive

Review Drive Default

SCSI Settings 2

Your internal tape drive comes with various default settings.

• The jumpers are located on the back of the drive, between the SCSI

interface and power connectors

• If you change a SCSI setting, you must turn the power to the drive off

and then on to have the new setting take effect.

You may need to change these settings to suit your requirements. Review

the default settings in table 3

to determine whether they suit your

requirements or need to be changed.

• If you do not need to change these default settings, proceed to

Prepare Mounting Bay

on page 11.

Table 3 SCSI Drives Only —

Tape Drive Default Settings

Note: These jumper pin settings are for the SCSI drive only.

Parameter Default Setting

SCSI ID 3

SCSI Controller 7

Host operating system Microsoft 2000, 2003, XP Professional, and

Linux Kernels 2.6 or higher

Note: The drive can be assigned any unused ID between 0 and 15.

Do not use SCSI ID 7, which is reserved for the SCSI controller.

SCSI ID 0 is typically assigned to the boot disk and should not

be used unless the tape drive is on a dedicated SCSI bus.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 81 82

Žádné komentáře

Quantum DAT 160 Uživatelská příručka Strana 23