Quantum Tape Drive LTO-3 Uživatelský manuál stáhnout pdf (Strana 22)

Chapter 2 Installation

Installing an Internal LTO-3 Tape Drive

8 LTO-3 Tape Drive User’s Guide

Installing an Internal LTO-3 Tape Drive 2

Installing an internal LTO-3 Tape Drive with an Ultra 160 SCSI LVD

interface involves the following steps:

1 Configuring an LVD Drive

2 Mounting the Internal LTO-3 Tape Drive on page 11

3 Connecting a SCSI Cable

on page 14

4 Checking the SCSI Termination

on page 15

5 Connecting a Serial Cable for Tape Libraries

on page 16

6 Bus Composition

on page 17

7 Registering Your Tape Drive

on page 18

Configuring an

LVD Drive

Before you install the LVD tape drive in your computer, you may need to

configure the drive’s SCSI ID and terminator power features. The default

configuration settings for the LTO-3 Tape Drive is:

• SCSI ID: 6

• Terminator power: disabled

If you need to change these settings, refer to the following sections.

Otherwise, proceed to Mounting the Internal LTO-3 Tape Drive

SCSI ID

Jumper Pins: 1–2, 3–4, 5–6, 7–8

Default Setting: SCSI ID 6

Each SCSI device on the bus must have its own unique SCSI ID. The

internal tape drive is shipped with a default SCSI ID of 6. If another SCSI

device in the SCSI chain is using this ID, use jumper pins 1–2, 3–4, 5–6,

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 97 98

Žádné komentáře

Quantum Tape Drive LTO-3 Uživatelský manuál Strana 22