Quantum Vision Rychlý návod stáhnout pdf (Strana 30)

30 Quantum Vision Setup

Quantum Vision 4.3.2 Quick Start Guide

The Ready to Install window displays.

8 Click Next or Forward to continue.

Wait while the setup wizard updates the software. When the setup wizard is

finished, the Completing the Quantum Vision Setup Wizard window displays.

9 Click Finish to close the setup wizard.

The Quantum Vision software is updated to the latest version.

Note: After the setup wizard is complete, Quantum Vision must update and

convert the database for optimum performance. The update process can

take up to two hours for large configurations. The Quantum Vision Web-

based interface will not be available during the update process. The

interface will become available after the update is completed.

10 Close your browser and open it again before accessing Quantum Vision. This clears

the browser cache.

Quantum Vision Setup

After installation is complete, you must set up Quantum Vision to begin monitoring

storage devices. To set up Quantum Vision, perform the following tasks:

• Logging On to Vision

• Discovering Devices

• Accessing the Console Command Line (virtual appliance only)

• Tak in g N ext S t ep s

Logging On to Vision Before you can begin setting up Quantum Vision, you must log on to the Web-based

user interface.

To log on to Quantum Vision:

1 Launch a supported Web browser on a workstation that has network access to the

Vision server.

2 In the browser address box, type the IP address of the Vision server, and then press

<Enter>.

The Login window displays (see Figure 34).

If the Login window does not display, verify that the IP address is correct and that

the network path to the Vision server is valid. Also verify that you are using a

supported Web browser and that the correct version of Adobe Flash Player is

installed.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Žádné komentáře

Quantum Vision Rychlý návod Strana 30