Quantum SuperLoader Uživatelská příručka Strana 157

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 196
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 156
Chapter 3 Media Changer Commands
Read Element Status Command (B8h)
Quantum ATL SuperLoader Software Interface Guide 139
Table 59 Data
Transfer Element
Descriptor
(1 byte)
Reserved
(1 byte)
Identifier Length
Field Name Description
Access When set to 1 it indicates access to the data transfer
element by the medium transport element is allowed.
When set to 0 it indicates access is denied. This may
occur if the device is performing an auto clean
operation.
Not Bus This field is sent as 0. The data transfer element is on
the same bus as the media changer device.
ID Valid When set to 1, it indicates that the SCSI BUS address
field contains valid information.
LU Valid When set to 1, it indicates that thee Logical Unit
Number field contains valid information.
Logical Unit
Number
If it is valid, it provides the logical unit number within
the SCSI bus device of the primary device served by
the media changer at this element address. This field
is always 0.
SCSI BUS
Address
If valid, it provides the SCSI address of the primary
device served by the media changer at this element
address.
NOTE: For fields not defined in this table, see table 56
on page 133.
Bit
Byte 7 654 3210
Zobrazit stránku 156
1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 195 196

Komentáře k této Příručce

Žádné komentáře