Quantum DLT 8000 Uživatelská příručka Strana 16

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 34
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 15
8 Sun StorEdge DLT8000 Tape Drive Installation and User’s Guide February 2001
Left Front Panel LEDs
Select Button
The Select button is used to select the record density of the tape cartridge. See
“Selecting Density” on page 14 for more information.
Cartridge Insert/Release Handle
Use the cartridge insert/release handle (only when the Operate Handle LED is on)
to load or eject a cartridge. The handle lifts to the open position and lowers to the
closed position.
TABLE 2-1 Left Front Panel LEDs
LED State Operating Condition
10.0/15.0 On/blinking
1
Tape is recorded in 10.0 or 15.0 Gbyte format.
20.0 On/blinking
1
Tape is recorded in 20.0 Gbyte format.
35.0 On/blinking
1
Tape is recorded in 35.0 Gbyte format.
40.0 On/blinking
1
Tape is recorded in 40.0 Gbyte format.
Compress
2
On Compression mode is enabled.
Off Compression mode is disabled.
Density Override On You selected a density from the front panel.
Off Density will be selected by the host.
Blinking The tape drive is in density selection mode.
All LEDs On POST is starting.
Blinking A POST error occurred.
1. A blinking LED signifies that you have used the Select button to choose a density other than the tape
cartridge’s default or pre-recorded density.
2. Compression can only be done in 10, 15, 20, 35, and 40 Gbyte densities.
Zobrazit stránku 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Komentáře k této Příručce

Žádné komentáře