Quantum LTO 1 Technické informace stáhnout pdf (Strana 7)

Installing the Internal LTO-3 Half-Height Tape Drive 7

LTO-3 Half-Height Tape Drive

Mount the internal drive in a 5.25-inch, half-height drive bay as follows:

1 As required:

a Save and close your open files and terminate all running applications.

b Shut down the workstation or server system.

c Disconnect the system AC power cord from the facility AC power receptacle.

2 Remove the cover from the workstation or server system.

3 Select an available 5.25-inch half-height bay and, if required, remove the bay cover.

4 Position the drive in the bay and align either the upper or lower mounting holes—

whichever is appropriate—with the holes in the chassis (see figure 5

5 Secure the drive using two M3.0 X 4 metric screws on each side

After mounting the internal LTO-3 Half-Height Tape Drive, proceed to Connecting the

Internal Drive Interface and DC Power Cables in the following subsection.

Figure 5 Internal Tape Drive

Mounting Hole Locations

Note: See your computer manufacturer’s instructions for the proper procedures

to remove the cover.

Caution: Using screws longer than 4 mm can damage the drive.

Do not use screws longer than 4 mm to secure the internal LTO-3 Half-

Height Tape Drive.

Lower mounting holes

Upper mounting holes

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Žádné komentáře

Quantum LTO 1 Technické informace Strana 7