Quantum DAT 240 Loader Uživatelský manuál Strana 28

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 51
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 27
20
Scorpion 240 Product Manual
Installing an external Scorpion 240
The external Scorpion 240 is a compact external SCSI device that connects to the
host computer as a turnkey subsystem. Installing the external drive involves three
simple steps:
1. Configuring the drive
2. Connecting the SCSI interface cable
3. Connecting the power cord
Configuring the external Scorpion 240
The following is the default configuration for the external Scorpion 240:
Drive configuration Default setting
SCSI ID 6
Media Recognition System (MRS) checking Enabled.
Parity checking Enabled.
Data compression Enabled.
Power-on self-test diagnostics Enabled.
Host operating system Windows 95/98/NT/2000
Termination power Supplied to the SCSI bus.
Note: Some of these configuration settings can be changed using the SCSI Mode
Select command. SCSI command information for these drives is provided in
the Scorpion 240 SCSI manual.
Setting the SCSI ID
Make sure that the drive is turned off; then set the SCSI ID for the drive using the push-
button switch on the back of the external drive. Figure 9 shows this switch, as well as the
two SCSI interface connectors, on/off switch, and the power-cord connector.
Note: The drive must be restarted for any change in SCSI ID to take effect.
+
68-pin wide SCSI
connectors
SCSI ID selector
On/Off switch
AC Power connector
Figure 9. Rear panel of external Scorpion 240
Zobrazit stránku 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 50 51

Komentáře k této Příručce

Žádné komentáře