Quantum DAT 432/864 Loader Uživatelská příručka stáhnout pdf (Strana 15)

Quick Start Installation Installing an Internal Autoloader

Installing an Internal Autoloader

Use the following procedure to install an internal autoloader. Print this page and check each step as

you complete it. If you need more information about a step, turn to the section referenced in the step.

❑

Unpack the contents of your drive package, and check for missing or damaged items.

See “Unpacking and Inspection” on page 16.

❑

Review the drive’s default settings and change them if necessary:

• SCSI ID: 6

• Parity Checking: Enabled

• Terminator Power: Disabled

• Data Compression: Enabled

• Media Recognition: Enabled

• Power On Self Test (POST): Enabled

• Host Operating System: Windows 98 SE/ME/XP/NT/2000/Windows Server 2003

• SCSI Interface Compatibility: Ultra 2 Wide SCSI for DDS-4 and DAT 72 autoloader

•Vendor ID: SEAGATE DAT

See“Configuring the Internal Autoloader” on page 20.

❑

Mount the drive horizontally in a 5.25-inch, full-height drive bay.

See “Mounting the Internal Autoloader” on page 24.

❑

Connect a SCSI interface cable to the drive.

See “Connecting the SCSI Interface Cable” on page 25.

❑

Be sure the tape drive is not the last device on the SCSI bus (the drive does not provide

SCSI termination).

See “Installing SCSI Termination” on page 26.

❑

Connect a power cable to the drive.

See “Connecting the Power Cord” on page 27.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 58 59

Žádné komentáře

Quantum DAT 432/864 Loader Uživatelská příručka Strana 15