Quantum DAT320 Drive Rychlý návod stáhnout pdf (Strana 9)

Installing the Internal DAT 320 Tape Drive in Your Server 9

DAT 320

Mounting Hardware Used

1 Use M3 screws. Check that the holes in the chassis are aligned with the holes in the

sides of the drive and use a regular Phillips screwdriver to secure the M3 screws (see

Figure 6

Figure 6 Securing Drive, No

Mounting Hardware Used

2 Ensure blanking plates are in place over empty bays and replace the cover on the

server.

Completing Your

Installation

To complete and test your internal tape drive installation:

1 Use the screws you removed earlier to secure the drive in place.

2 Replace the computer cover.

3 Reconnect the power cord to the computer’s power connector.

4 Turn on the computer.

5 If necessary install the DAT320 O/S driver.

6 Install your backup software program. The documentation that came with your

software should describe this procedure.

7 Gently insert a tape cartridge into the internal tape drive’s slot. Slide the cartridge

into the slot until the drive accepts the cartridge and loads it. A brief delay occurs

while the drive identifies the cartridge type and state, and moves the tape to the

data area. Then the green Ready LED goes ON.

8 Use your backup software application to perform a sample backup-and-verify

operation. The Ready green LED flashes as data is written to and/or read from the

tape.

9 At the end of the operation, press the

Eject button on the front of the internal tape

drive to eject the cartridge from the drive.

M3 screws, supplied

with tape drive

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Žádné komentáře

Quantum DAT320 Drive Rychlý návod Strana 9