Quantum LTO-5 Rychlý návod stáhnout pdf (Strana 10)

10 Installing the Internal LTO-5 Tape Drive

Product Name Quick Start Guide

Figure 7 Internal Full-Height

Drive Interfaces

29-pin SFF-8482 SAS cable connector

4-pin Molex power

connector

Connect the interface cables to the internal drive as follows:

1 V

erify that the system is shut down and the AC power cord is disconnected from the

facility AC power receptacle.

2 Conne

ct the SAS connector on the back of the tape drive to a serial SCSI host bus

adapter (HBA) installed in the server.

3 Ensure

that a 4-pin Molex power connector is plugged into the power inputs of the

SAS cable as shown in figure

4 Reinstall the system cover

5 Reconn

ect the system AC power cord to the facility AC power receptacle.

After connecting the internal drive interfaces, proceed to Restarting the Internal Full-

Height Tape Drive System in the following subsection.

Restarting the Internal Full-Height Tape Drive System

After connecting the internal drive interfaces:

1 Restart

the workstation or server system.

2 V

erify that the internal LTO-5 Full-Height Tape Drive comes on and completes the

Power On Self Test (POST) functions.

As required, proceed to Installing the LTO Driver Software on page 14.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Quantum LTO-5 Rychlý návod Strana 10