Quantum SuperLoader 3 Uživatelský manuál stáhnout pdf (Strana 2)

2 Dislodging a Stuck Tape

SuperLoader 3 Stuck Tape Removal Instructions

Dislodging a Stuck Tape

Use the following steps when dislodging a stuck tape in a SuperLoader 3:

1 Power cycle the unit using the power switch located at the rear of the system. Wait

at least 10 seconds after power down before powering up the unit.

The Operator Control Panel (OCP) on the front of the unit displays the following

status (see Figure 1).

Figure 1 OCP, Initializing

While the system is running this sequence, several clicking sounds are heard while

the system attempts to rotate the turntable mechanism. Commands can not be

entered through the OCP until this initialization completes. This process can take up

to 10 minutes.

The system attempts to adjust and move the stuck tape. If the stuck tape cannot be

moved, after a period of time the noise should stop. The OCP displays this or

another error (see an example of an error below in Figure 2).

Figure 2 OCP, System Error

Type (AE) - Example of Error

1 2 3 4 5 6 7 ... 17 18

Žádné komentáře

Quantum SuperLoader 3 Uživatelský manuál Strana 2