Quantum Scalar i500 Uživatelská příručka stáhnout pdf (Strana 371)

100

101

Chapter 12 Installing, Removing, and Replacing

Adding Expansion Modules to an Existing Library

Scalar i500 User’s Guide 352

a From the front of the library, open the I/E station and access

doors of the expansion module.

b Squeeze the handle of the Y-rail release mechanism, lift it out of

its locked position, and slide it downward as far as it will go.

c From the back of the library, find the rear Y-rail release

mechanism, which is located in the interior of the right side of the

module. Squeeze the handle of the Y-rail release mechanism, lift

it out of its locked position, and slide it downward as far as it will

go.

Doing this aligns the Y-rails with the Y-rails of the module

beneath it.

Caution: Check to make sure that there is no gap between the top

and bottom Y-rails on both the front and back of the

library. If a gap exists, the library cannot mechanically

initialize.

1 2 ... 366 367 368 369 370 371 372 373 374 375 376 ... 569 570

Komentáře k této Příručce

Žádné komentáře

Quantum Scalar i500 Uživatelská příručka Strana 371

Komentáře k této Příručce

Související produkty a manuály pro ne Quantum Scalar i500