Quantum Qflash X4d Provozní pokyny stáhnout pdf (Strana 15)

The Flash Indicators light for several seconds after a flash. See 5.10.2

above for the signals they display.

The Speaker (if turned on, Section 5.9.4) will sound after a flash. The audi-

ble signal is one “beep” for OK and “ready”, and three “beeps” for Under

or Over.

In addition to OK / Under / Over exposure indicators, a ‘Limit’ indicator is

added if the Auto Sensor Limit has been selected (Section 5.9.1). If the

flash output has reached the sensor limit set (5, 10, 15 or 20ft. / 2, 3, 4,

6m) then the word ‘Limit’ will appear in the display, followed by a three

beep and/or 3 blink warning. If the flash output did not reach the sensor

limit then ‘OK’ will be indicated visually and audibly.

5.10.4 TTL mode exposure indications

The exposure indications for TTL or QTTL mode are similar to those of

Auto mode with one exception. The amount of Under or Over exposure will

not be shown in the display.

5.10.5 Strobo mode indicator

After the flash has finished firing a

confirmation message will be dis-

played. The flash will display the

actual number of flashes fired.

Strobo is a manual exposure mode.

Over and Under exposures are not

indicated.

5.10.6 Flash exposure when using several flashes at once

When the flash is in Wired Control (Section 7.0) or Wireless Control

(Section 8.0) the total exposure created by all the flashes, whether OK,

under or over, will be indicated in the Control Qflash display, and by Flash

Indicators and the Speaker (when turned on). Ambient light corresponding

to 1/125 second shutter time is included in the total exposure.

5.10.7 Restoring Factory settings

Qflash options and settings are preset at

the factory. You can restore the factory

settings by the following method:

1. Connect Qflash to Turbo or Qpaq, but turn Turbo or Qpaq OFF first.

2. Press and hold any button (except Test M).

3. Turn Turbo or Qpaq ON.

4. The Qflash will display a reset message.

5. Press Mode I to reset the Qflash and restore the factory settings.

If any other button or no button is pressed within 4 seconds, the flash will

not restore the factory settings.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Žádné komentáře

Quantum Qflash X4d Provozní pokyny Strana 15