Quantum Scalar 100 Uživatelská příručka stáhnout pdf (Strana 29)

SNC 6101 User’s Guide 25

SNC > rtcDateSet 2004,1,8,2,13,8,0

13 Use the dateSetFromRTC command to set the real time clock on the SNC as the source of date

display.

SNC > dateSetFromRTC

value = 0 = 0x0

SNC >

14 Use the tzSet command to set the timezone. EST, used in the example, stands for Eastern Standard

Time.

SNC> tzSet "EST"

TZ Set TIMEZONE = EST:EDT:300:040202:101502

value = 0 = 0x0

SNC >

15 Use the date command to confirm.

SNC > date

SNC > THU JAN 08 13:10:06 2004

SNC> > value = 0 = 0x0

16 Rebuild the SNC 6101 database and initiate a reboot by typing:

mapRebuildDatabase

Updating SNC 6101 Firmware

The SNC 6101 should always contain the latest firmware from ADIC. Use the service port to identify the

installed firmware version by typing version. Check www.adic.com

to determine if a newer version is

available. If an upgrade is available, download the newer version (user name and password required) and

follow these procedures:

To upgrade SNC 6101 Firmware

1 Ensure that the SNC 6101 and its host computer are connected to the network as illustrated in Figure

9 on page 20.

Note

Use a 24-hour clock and Greenwich Mean Time when setting the RTC.

Note

A digit from 1-7 must be entered for the [dayofweek] parameter, but it does

not matter what you enter, since the command will automatically correct it if it is

wrong.

Note

The time will be one hour off while daylight savings time is in effect unless you

reset the RTC during that period.

Note

Firmware can be updated either through the service port using the rz

command to initiate a Zmodem file transfer session with HyperTerminal, or

through the SNC 6101 Ethernet port using file transfer protocol (FTP). The

following procedure uses FTP as an example.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Žádné komentáře

Quantum Scalar 100 Uživatelská příručka Strana 29