Quantum TC2201 Uživatelská příručka stáhnout pdf (Strana 144)

Backup/Restore Configuration Settings

Quantum TC2201 User’s Guide 124

The default IP address is 1.1.1.1.

3 Enter the user name and password. The default values for user name

and password are

root for the user name and password for the

password.

4 Specify binary mode:

bin

5 Specify the filename (.cfg file) with the get command:

get filename.cfg

(where “filename.cfg” can be any name for the configuration file.)

The file will transfer to the current directory specified on your computer’s

FTP utility. If running FTP from a DOS or Linux command line, the

destination directory can be set using the lcd command (ex. lcd

c:\myCfg).

Configuration Restore

Procedure

To restore a configuration file:

1 Connect the TC2201 to the ethernet network used by your computer.

2 Start your FTP program using the TC2201’s IP address:

Note: If the TC2201 is to use a static IP address, the default IP

address 1.1.1.1 should be changed to an address that is

appropriate for the IP network it will reside on. Note that the

default IP address can be used in a direct connection between

the TC2201 and the host computer via a crossover Ethernet

cable.

Note: You may also need to specify the directory location on your

computer or network where your FTP program will store the

backup file.

Note: World Wide Name (WWN) values and Ethernet physical

address (MAC address) values will not be saved. Because user

defined values for these settings are not retained in the

configuration backup file, they must be re-entered after the

configuration is restored. See the Configuration Restore

Procedure later in this chapter for more information.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 163 164

Žádné komentáře

Quantum TC2201 Uživatelská příručka Strana 144