Quantum EC-LLDAA-YF-B Uživatelská příručka stáhnout pdf (Strana 86)

Chapter 5 Administration

Setting Ethernet

66 Quantum SuperLoader 3 User’s Guide

To set or change the Fibre Channel parameters:

1 If the main menu is not already visible, press

Enter.

2 On the main menu, scroll to

Configuration and press Enter.

3 On the

Configuration submenu, scroll to Fibre Channel and press

Enter.

4 Scroll to the parameter you want to set or change (

Set Topology, Set

FC Speed

, or Set Loop ID), then press Enter.

•

Set Topology allows you select Auto Negotiate, Loop, or P2P.

•

Set FC Speed allows you to select Auto Negotiate, 1 Gig, or 2 Gig.

•

Set Loop ID allows you to select a Loop ID of 0 – 127 (only if Loop

is selected with

Set Topology).

5 Press and hold the power button on the front panel when

Please

Cycle Power

displays on the LCD.

Power Off displays on the LCD, then the autoloader shuts off.

7 Press the power button again to power on the autoloader.

The new Fibre Channel parameters are now in effect.

Setting Ethernet

Ethernet is the method used by the autoloader to access a network.

With an Ethernet connection, you can remotely access the autoloader

over the network. To use the Ethernet connection, you must define the

following:

• A dynamic or static IP address for the autoloader (required)

• A subnet mask (required)

• An IP gateway (optional)

• A Simple Network Management Protocol (SNMP) server (optional)

• A time server, or set the time and time zone manually (optional)

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 209 210

Žádné komentáře

Quantum EC-LLDAA-YF-B Uživatelská příručka Strana 86