Quantum Scalar i40 Uživatelská příručka stáhnout pdf (Strana 162)

Chapter 5: Performing Library Operations

Cleaning Tape Drives

136 Quantum Scalar i40 and Scalar i80 User’s Guide

3 If more than one partition exists, select the partition that contains

the tape drive you want to clean, and click Next.

The Clean Drive -

Partition (Mode)

screen appears, where

Partition

is the name of the partition and

Mode

is the current mode (online/

offline) of the partition. This screen contains a list of tape drives

assigned to the partition.

4 If you have no cleaning slots configured, skip this step (you will use

the top I/E station slot as the source for your cleaning cartridge). If

you have at least one cleaning slot configured, you are asked to

Select Cleaning Source. Select which location to take the cleaning

cartridge from:

• Use the top I/E slot — Allows you to use a cleaning cartridge

from the topmost I/E station slot. Make sure to install a cleaning

cartridge in the topmost I/E station slot. If manual cartridge

assignment is enabled, assign the cleaning cartridge to the

System partition.

• Use configured cleaning tapes — Allows you to use a cleaning

cartridge from a configured cleaning slot. If two or more

cleaning slots are configured and have cleaning cartridges in

them, the library chooses which cleaning cartridge to use.

5 Select one or more tape drives to clean.

Note: If not all tape drives appear on the screen, use the Page 1

of x arrows to view the additional tape drives.

Note: Bold column headings in the table can be sorted. For

example, selecting the Location column heading will sort

by location coordinates.

6 Click Apply.

7 Click OK to confirm it is OK to take the partition offline.

The library moves the cleaning cartridge to the tape drive and cleans

it. When finished, it moves the cartridge back to the cleaning slot or

I/E station.

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 327 328

Žádné komentáře

Quantum Scalar i40 Uživatelská příručka Strana 162