Quantum ACL 452 Instalační příručka stáhnout pdf (Strana 40)

Chapter 3 Installing the Library

Setting Up and Testing the Library

24 ACL 4/52 Facilities Planning and Installation Guide

Setting Up and Testing the Library

The following procedures verify the proper operation of the ACL 4/52

library:

• Turning on the library

• Setting SCSI addresses

• Configuring library options

• Running a system test

• Performing an inventory

Turning On the

Library

To turn on the library:

1 Verify the following:

• Actuators move freely in the horizontal and vertical directions

• All doors are closed

• All cosmetic panels are attached

• Power switch in the

(off) position

Caution:

Using a digital voltmeter (DVM), verify that the facility

power is

90-132VAC or 180-264 VAC @ 47-63Hz before connecting

the AC power cord.

2 Connect the AC power cord to the rear panel and facility power.

3 On the rear panel, set the power switch to the “|” (on) position.

4 After several seconds, verify that the control panel displays library

status.

Setting SCSI Addresses

After power is applied to the library, you need to set library and tape

drive SCSI addresses. Setting SCSI addresses require operator- or

service-level security clearance at the library control panel.

Configuring Library

Options

In addition, you may want to change the default configuration (in

bold) of these options:

• Library power-up state (online/offline)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 67 68

Žádné komentáře

Quantum ACL 452 Instalační příručka Strana 40