Quantum 200D/400D Uživatelská příručka stáhnout pdf (Strana 28)

16 Operation and Maintenance

Power-on Self-Test and Initialization

When the system power is turned on, the drive performs a Power-on Self-Test (POST) and initialization. POST is completed in

approximately three minutes and the drive will respond normally to all commands. However, it may take longer for the media to be ready.

Following POST completion, the Status LED will be solid green.

Drive Status

LCD Messages

Table 3-1 describes the messages displayed on the LCD during and immediately after the POST:

Table 3-1 POST LCD Messages

Drive State

Message

POST is executing.

Power On Self Test

In Progress

Will be displayed for several minutes, followed by:

Drive FW X.X.X

Display FW X.X.X

“DRIVE FW” is the firmware version of the drive.

“DISPLAY FW” is the firmware version of the LCD controller.

POST completed and no cartridge is

present.

Ultrium Tape Drive

Drive Empty

POST completed and a cartridge is

present.

Volume Loaded DC WP

Ready...

“DC” indicates that drive data compression is enabled

“WP” indicates that cartridge is write-protected.

The drive detects an error condition.

Error!

Selftest Failure

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 64 65

Žádné komentáře

Quantum 200D/400D Uživatelská příručka Strana 28