Quantum 200D/400D Uživatelská příručka stáhnout pdf (Strana 54)

42 Troubleshooting and Diagnostics

If an error is detected, the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, flashing

Single-character display

LCD

Error!

Media Problem

and your LTO standalone will exit Maintenance Mode.

To resolve the error, refer to Table 4-2 Error Codes, elsewhere in this chapter.

Fast R/W Diagnostic

Use this function to determine whether the drive can properly load and unload cartridges, and read and write data.

To select the Fast R/W Diagnostic, perform the following steps:

1. Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.

2. Press the Unload button once per second until the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, solid

Single-character display

LCD

Maint Mode: Select

Fast R/W Diagnostic

3. Press and hold the Unload button for two seconds to select Fast R/W Diagnostic.

After a short time the front panel indicators display the following:

Indicator State, Character or Message

Status LED

Amber, solid

Single-character display

C, flashing

LCD

Fast R/W Diagnostic

Load Scratch Tape

4. Within 60 seconds, insert a scratch data cartridge that is not write-protected into the drive (or the drive will exit

Maintenance Mode). Refer to Convert FMR Tape to Scratch Tape elsewhere in this chapter for the description of a

valid scratch data tape.

Caution

Insert only a scratch data cartridge for these tests. Data on the cartridge will be

overwritten.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 64 65

Žádné komentáře

Quantum 200D/400D Uživatelská příručka Strana 54