
96 Performing Advanced Tasks and Operations
Removing Internal Backup Media
Use this procedure to remove internal backup media from the Pathlight VX by sending it to the I/E station
of an attached physical library.
1 From the menu bar, select Operations→ Media Management→ Physical→ Internal Backup.
The Operations - Manage Internal Backup Media screen appears and lists the internal backup media
in the Pathlight VX. For each media, the following information is provided: the media's barcode, media
type, and library where the media is located.
2 In the Select Operation area, select Remove.
3 Click Next.
The Internal Backup Media - Remove screen appears and lists internal backup media that can be
removed from the Pathlight VX.
4 Select one or more internal backup media to remove from the Pathlight VX.
• To select one or more internal backup media, check the box next to each media's barcode.
• To select all internal backup media, check the box next to Barcode.
5 Click Apply.
The Progress Window appears.
• If Success is shown in the Progress Window: The selected internal backup media was
successfully sent to the I/E station of the attached physical library.
• If Failure is shown in the Progress Window: The selected internal backup media was not sent to
the I/E station of the attached physical library. To view the troubleshooting procedures, click View
Recommended Actions. To view the error details, click Error Log for information on why the
removal procedure was not successful. To remove additional internal backup media from the
Pathlight VX, repeat Step 1
through Step 3.
6 Click Close to close the Progress Window.
7 Remove the media from the I/E station of the attached physical library.
Related topics:
Removing Application Media
on page 93
Removing Cleaning Media
on page 94
Removing Disk Extension Media
on page 95
Removing Service Media
on page 97
Note
If you remove all internal backup media from the Pathlight VX, then you
cannot save system backups to tape.
Note
Once the Progress Window appears, you cannot cancel or stop this action.
However, you can close the window by clicking on the X in the upper-right of
the screen, but confirmation of success or failure is NOT shown.
Komentáře k této Příručce