
74 Performing Basic Tasks and Operations
5 Modify the name, type and/or the WWN of an FC Host.
6 Click Apply.
The Progress Window appears, which contains information on the status of the modified FC Host.
• If Success appears in the Progress Window: The FC Host was successfully modified.
• If Failure appears in the Progress Window: The FC Host was NOT modified. To view the
troubleshooting procedures, click View Recommended Actions. To view the error details, click
Error Log for information on why the FC Host was not modified. To modify another FC Host, repeat
Step 2
on page 73 through Step 6.
7 Click Close to close the Progress Window.
Related topics:
Configuring an FC Host
on page 70
Removing an FC Host
Removing an FC Host
Use this procedure to remove an FC Host that has been disconnected from the Pathlight VX. If the Pathlight
VX has dual FC blades in the SNC and the FC Host is associated with both FC blades, then this procedure
must be performed two
times to remove the FC Host from both FC blades.
1 From the menu bar, select Setup→ Host Access.
The Setup - Host Access screen appears and lists all virtual libraries in the Pathlight VX.
2 Select one or more virtual libraries in the Pathlight VX.
• To select one or more virtual libraries, check the box next to each library's name and click Next.
• To select all of the virtual libraries, check the Name box and click Next.
The Setup - Host Access - vlib screen appears, where vlib is the name of the selected virtual library
or libraries.
Note
Once the Progress Window appears, you cannot cancel or stop this
action. However, you can close the window by clicking on the X in the
upper-right of the screen, but confirmation of success or failure is NOT
shown.
Note
Selecting one or more virtual libraries has no bearing on the operation to
remove an FC Host. The virtual library selection is an artifact, and it does
not matter which library or libraries are selected.
Komentáře k této Příručce