Quantum Scalar 100 Uživatelská příručka Strana 78

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 130
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 77
70 Configuring your Library
Reading Barcodes of Media in Tape Drives
Use Scan Media to configure your library so that whenever it takes inventory, the barcode number of all
media currently in tape drives is read and stored.
With this command selected, when inventory is taken during power up or when the door is opened, the
picker moves any tape cartridges that are in a drive to the first available storage slot and then reads the
barcode. If configured to do so, the picker then moves the tape cartridge back to the drive from which it was
taken.
Path: Main Menu > More > Setup > Library > More > Scan Media
1 From the main menu, select More and then select Setup. Select Library and then Scan Media.
2 In the first field, indicate using Yes/No whether or not to scan the barcodes of tape cartridges in drives.
3 In the second field, use Yes/No to indicate whether or not to place the tape cartridges back into the
drives after their barcodes have been scanned.
Configuring Barcode Length
Use Media to configure the barcode length (volser) your library reads. The library can read an extended
barcode label, 5 to 13 characters. However, you can configure your library to read six character barcode
labels.
For more information on barcode labels, refer to Barcode Label Requirements on page 86.
Path: Main Menu > More > Setup > Library > Media
1 From the main menu, select More. Select Setup and then select Library. Select Media.
2 Use Change to select one of the following:
DEFAULT — The library reads 6 character barcode labels.
EXTENDED — The library reads 5 to 13 character barcode labels.
3 Select OK.
Zobrazit stránku 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 129 130

Komentáře k této Příručce

Žádné komentáře